![]() Close your computer, then connect your display to your new graphics card.Connect one or two PCI-E connectors from the power supply. The power supply connector port should be at the top of the card. Once the card is firmly in place, use the case screws to secure it to the chassis.If there’s a clip, you’ll hear it click into place. To get it completely seated, apply a little pressure to the top. Insert the card into the empty PCI-E slot. Before you start, ensure there are no cables or other components in the way.Avoid touching any circuitry or contacts when removing the graphics card from its anti-static bag.Part Seven: Install Your New Graphics Cardįollow these steps to install your new graphics card: So, to help extend the life of your PC, give it a good clean once in a while. A build-up of dust can cause the components to overheat. You can use canned air/compressed air to remove the dust from all the crevices. Opening up a tower would be a great time to get rid of the accumulated dust over time. To prevent causing damage to the PCI slot, pull the card upwards as you remove it.On newer cards, near the back of the PCI slot, a tab underneath just needs to be released to pull the graphics card out. With a crosshead screwdriver, unscrew the screws connecting the card to the chassis.Ensure all cables connected to the graphics cards are removed from the back panel.Part Five: Remove Your Old Graphics Cardįollow these steps to remove the graphics card: The graphics card will likely be the largest card slot on the board, with fans and heatsinks attached to it. If your computer is an older model, the graphics card will be inserted into the AGP slot.This should be the first or second expansion slot. Locate the long PCI-E x16 nearest to the heat sink of your CPU.In that case, skip this section and go to Part Six. If your monitor were connected directly to the motherboard for integrated graphics, you wouldn’t have a graphics card to remove. Lay your PC on its side, then unscrew the opposite panel.It’s a panel with various ports like USB, Ethernet, etc. To know which side your motherboard is on, look on the back of your PC for the I/O panel.For easy access to your motherboard, start at the end opposite.Once all the peripherals are disconnected, to remove the side panels: Alternatively, you could use a Philips-head screwdriver. Many modern cases have thumbscrews on the back for easier removal of the side panels. Now that you’re grounded, it’s time to open your computer case. Ensure the computer is disconnected from the power supply.Ensure your computer is on a table and not your carpet.Use an anti-static wrist strap attached to exposed metal in the computer case. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |